Has anyone taken a swaped
10-30-2003, 06:05 AM
#1
Thread Starter
Join Date: Oct 2003
Location: Georgia
Posts: 11
Has anyone taken a swaped
I own a 99 cobra 4.6. I would like to put a 5.4 core engine into my cobra. I hear the cheapest way is to get a used 5.4 from a junkyard, forge it and put it in your cobra. Has anyone heard of anyone doing this, know about how much it would cost installed,and if so do you have any advice for me? Thanks
10-30-2003, 10:25 AM
#2
I ♥ Acer
Join Date: Sep 2003
Location: United States
Posts: 8,826
Has anyone taken a swaped
Ive seen some articles in magazines where its been done fairly easily, I think there was one done in this months 5.0 or mm&ff. But... youve got a 99+ Cobra motor... Id rather have that than a 5.4... unless that 5.4 was cammed and blown 
10-30-2003, 07:29 PM
#3
Thread Starter
Join Date: Oct 2003
Location: Georgia
Posts: 11
Has anyone taken a swaped
A 5.4 bottom end would give me a lot more torque then my 4.6 though right? And it would give me the chance to beef up the bottom end with forged pistons and rods. Don't the Cobra R's have a 5.4 bottom end?</P>
Thread
Thread Starter
Forum
Replies
Last Post
