96 gt pi intake swap
#1
96 gt pi intake swap
im getting ready to swap intakes tomorrow, and just wanted to make a couple things clear.. because im putting a pi intake on the non pi motor i need to take off the water pump and put the pi oring on? My engine has only 45,000 so should i just replace the waterpump if im taking it off, i plan on selling the car in a few months... also on one site i read that the pi gaskets dont line up quite right with the pi heads and requires some trimming?? i dont actually have a whole lot to ask now but probly will tomorrow as im right in the middle of it .. can you please post some write ups you have or have found, ive been searching and trying to read them all.. thanks bren
#4
RE: 96 gt pi intake swap
I think you should do some more reading up on it before you actually start to try and tackle it...
CLICK HERE, that's a pretty good write-up about what all needs to be done.
CLICK HERE, that's a pretty good write-up about what all needs to be done.
#5
RE: 96 gt pi intake swap
the p.i. intake it almost a direct swap you can gain somewere around 18rwhp from the swap itself even more if you had a more direct port match betwen the npi heads and the p.i intake so good luck to you
Thread
Thread Starter
Forum
Replies
Last Post
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM