Trick FLow Or Dart PRo 1 CNC
#2
RE: Trick FLow Or Dart PRo 1 CNC
I talked to an old-timer at the machine shop by me....and he says go with anything but Darts. He also dogged on Edlebrock real bad too...
I went with Trickflows, and am happy with them. But everyone on here will tell you that AFRs are the way to go!
I went with Trickflows, and am happy with them. But everyone on here will tell you that AFRs are the way to go!
#4
RE: Trick FLow Or Dart PRo 1 CNC
I was suprised too...but the old man said, "No Way!"
He wasn't trying to sell me anything either...he had me in there for like an hour schooling me on Heads...
He said one of the biggest problems is the valves. Just because the Head has a good name on it, does not mean there is agood set of valves in there...
I cannot remember if valves was hisreason against Darts...but I do remember him saying they were garbage.
He wasn't trying to sell me anything either...he had me in there for like an hour schooling me on Heads...
He said one of the biggest problems is the valves. Just because the Head has a good name on it, does not mean there is agood set of valves in there...
I cannot remember if valves was hisreason against Darts...but I do remember him saying they were garbage.
#5
RE: Trick FLow Or Dart PRo 1 CNC
http://www.adperformance.com/index.p...Path=68_99_257
hwhere did you find these heads for $1100 let me know cause i will take a set.
hwhere did you find these heads for $1100 let me know cause i will take a set.
#7
RE: Trick FLow Or Dart PRo 1 CNC
*****Nevermind, just read your post above. I'd say go with the high ports. CNC high ports normally sell for over $2000. The twisted wedges are a little cheaper.
Where can you get trickflow cnc high ports for $1100! I'll order them today if some place has that deal going.
ORIGINAL: fishermanjesse
wondering which one to purchase the Trick Flow Cnc high port heads or the Or Dart Pro 1 Heads?both are 1,100$
wondering which one to purchase the Trick Flow Cnc high port heads or the Or Dart Pro 1 Heads?both are 1,100$
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM